Top rated pneumatic press machine manufacturer 2022? World has been committed to the development and production of power press machines since it was established in 1953. More than 100 experienced engineers are working in the three R&D centers, one in Shanghai, one in factory and another one in Ningbo. Discover even more info on pneumatic press machine. Through this partnership of shared experience and ideas, we are confident that we can realize your current and future requirements on WORLD press machine.
The imprint bending is the same as the bending of the bottomed die, except that the front end of the punch is processed to the required bending radius, and the gap between the punch and the die at th bottom of the stroke is smler than the material thickness. Since enough presure approximately 10 timesof fee bendig is applied to force the front end of the punchto contact the material, springback is basically avoided.
Hydraulic transmission is adopted, and the slider part is composed o slide, an oil cylinder and a fine-tuning structure of a mechaicl stoper. Te left and right oil cylinders are fixed on the frame, the piston (rod) drives the slider to move up and down through hydraulic pressure, and the mechanical stop is controlled by the numerical control system to adjust the value; Workbench part: controlled by the button box, the motor drives the stopper to move back and forth, and the moving distance is controlled by the numerical control system. The minimun reading is 0.01 mm (the front and rear positions have travel switch limits).
Under the same load, the deflection of the worktable and sliding block of the 10-foot machine is 4 times that of the 5-foot machine. This means that shorter machines require fewer shim adjustments to produce qualified parts. Reduced shim adjustment and shortened preparation time. Material grade is als a key factor. Compared with low-arbon sel, the load required by stailes stee is usuall increasedby about 50%, while most grades of soft aluminum are reduced by about 50%. You can get the machine’s tonnage table from the bending machine manufacturer at any time. The table shows the estimated tonnage required per foot length unde diffrent thicknesses and different materials.
In particular, the resilience stress stat,the flatness and the cuting quality are very important quality characteristics that must be considered for the materials n the staightening and feeding technology. Remarkably, these criteria play a decisive role i te qualit of the final product even befre te final molding. In production, for reasons of cost and time, the aim is to achieve an ever-higher degree of automation, which can only be achieved if the semi-finished products have perect latness, a lowlevel o residual stress. lf these requiremets are not met, this can have a negative effect on handling and further processing or even make it impossible. Read extra information at https://www.pressmachine-world.com/.